Plaster
Clay plaster
Split lath was nailed with square cut lath nails, one into each framing member. With hand split lath the plasterer had the luxury of making lath to fit the cavity being plastered. Lengths of lath two to six foot are not uncommon at Economy Village. Hand split lath is not uniform like sawn lath. The straightness or waviness of the grain affected the thickness or width of each lath, and thus the spacing of the lath. The clay plaster rough coat varied to cover the irregular lath. Window and door trim as well as the mudboard (baseboard) acted as screeds. With the variation of the lath thickness and use of coarse straw and manure, the clay coat of plaster was thick in comparison to later lime-only and gypsum plasters. In Economy Village, the lime top coats are thin veneers often an eighth inch or less attesting to the scarcity of limestone supplies there.
Cement plaster
Cement plaster was first introduced in America around 1909 and was often called by the generic name adamant plaster after a prominent manufacturer of the time. The advantages of cement plaster noted at that time were its strength, hardness, quick setting time and durability.
Heat-resistant plaster
Heat-resistant plaster is a building material used for coating walls and chimney breasts and for use as a fire barrier in ceilings. Its purpose is to replace conventional gypsum plasters in cases where the temperature can get too high for gypsum plaster to stay on the wall or ceiling.
Reading List
Report Issue